Results 1 to 2 of 2

Thread: NES Screwdriver/Screws

  1. #1
    Insert Coin (Level 0)
    Join Date
    May 2010
    Posts
    30

    Default NES Screwdriver/Screws

    Been looking everywhere for this information and can't seem to find a clear answer.

    Basically, what kind of Phillips screwdriver do I need to remove the 6 outside screws of the Nintendo. I've now bought 3 different screwdrivers and none of them seem to work. I have size #0, #00, and #000 Phillips Screwdrivers but they don't seem to fit properly.

    Could anyone tell me specifically what Phillips Screwdriver to use. I really would like to open my Nintendo to replace the 72 pin connector.

    Much thanks in advance.

  2. #2
    Strawberry (Level 2) Compute's Avatar
    Join Date
    Feb 2009
    Location
    Appleton, WI
    Posts
    462
    PSN
    compute1984

    Default

    I use a P2 for the larger screws (on the outside) and P1 size for the smaller screws inside. Make sure the shaft is at least 4" long to get all the way in. There is not anything in there smaller than a P1-size screw head, so you don't need anything fancy. It can be difficult to get those case screws with an improperly-sized screwdriver. P2 should nestle right in there.
    See my latest arcade repair at the Holodeck 2 Arcade Repair Blog: http://holodeck2arcade.blogspot.com

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •